![]() I downloaded the 2.6.1 ARM multi-touch driver (note that version #'s and links change… you may need to search ELO's site again and figure out the links. $ sudo apt-get install raspberrypi-kernel-headers I think some issues are specific to my situation but most is the same for everyone. There are some options at the end depending on what works for you. ![]() ![]() They receive the access codes through SMS once we get it up and running.Ĭode: Select all Here are my steps for the ELO 2515. through Vantage domotics system from the outside when visitors have entered our building. PS: the Pi + touchscreen is to serve as an keypad and interface for opening the door / carport /. Anybody here to point a bloke in the right direction? I lurked around the other boards, but I seem to have different problems than the related posts when I was searching. Nothing registers however, and from the output I'm inclined to think that it registers on hardware level on the bus, but not when touched.ĭoes anybody have any experience with this specific model from Elo - or with Elo in general? Input device name: "Elo TouchSystems Elo TouchSystems 2515 iTouch Plus USB Touchmonitor" Input device ID: bus 0x3 vendor 0x4e7 product 0x126 version 0x111 Code: Select all > sudo evtest /dev/input/event2
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |